Should use the subfile, not have it fully inlined.

s\3941s01.dat cant be used because the print is bigger

Yes Rene, you're absolutely right! I haven't found anything better...

Then please adapt the existing subfile so that it could be used.
Make a version without the blocking surface, and then use it in your part, and in the s01 subpart.

The subfile is official...

But would it be possible to include the stud logos to the new subfile?

No stud logos, please in the official parts.
But they are included in the library, to add in your own copy of the stud.dat file, if you want studs with a logo.
I use logo.dat in my copy. It makes it easy to detect incorrect studs when I do a review.

In this case, there is logo information in the stud group stug10-2x2.dat
Open that file and activate the code.

Regarding the 3941s01.
Make a new file, 3941s02.dat. Move the code of s01, but leave the unwanted surface.
Then use s02 in s01, to maintain backward compatabillity, and send the new version of s01 to part admin.

Or, since there are only 2 files using s01, edit s01 and add the unwanted surface in 3941 and 3941p01.
Send them all to admin.

Replacement of 5-16ring2 by 5-16rin2

Replacement of 1-16ring2 by 1-16rin2

You need to add some 1-16chrd on the non-shapeshifting quads in the eye.
The pattern cracks open in hi-res mode.

Some vertices have too many decimals.

Update ring primitives via script. This will not reset the vote status of the part.

The pattern should also be realigned, so the pattern is to the "front" (and not to the "side").